Röda och smutsiga vita ränder randig tapet
Referens: P1375Röda och smutsiga vita ränder randig tapet
Glöm ryggsmärtor och irriterande utrustning du behöver för att renovera utseendet i dina väggar. Vår produkt är speciellt designad för att göra det enkelt för dig. Bara mät dimensionerna på dina väggar och beställ så många tapetrullar du behöver.
Du får en uppsättning tryckta instruktioner med produkten, vilket gör installationen ännu enklare för dig.
Förnya vardagsrummet med röda och vita ränder
Vår randiga tapet i rött och vitt är perfekt för att förändra utseendet på ditt vardagsrum. Med våra produkter kan du enkelt skapa en unik atmosfär i varje rum i ditt hus. Oavsett om du vill ha en modern eller klassisk stil, kan du välja bland olika färger och mönster för att skapa den perfekta inredningen.
Om du inte har lim, en skärare eller någon annan saknad bit för att installera designen kan du enkelt beställa det hos oss. Vi har allt du behöver för att få ditt projekt att bli verklighet.
GRAMMERING - 180 g/m2
APPLIKATION - Lim på vägg eller på papper
FÄRG - Matt yta
M2 REAKTION PÅ BRANDCERTIFIKAT
MATERIAL - Icke-vävt tyg
LÄTT ATT RENGÖRA - Med fuktig trasa och neutral tvål
1. Glue for photomurals and wallpaper.
2. Bucket to prepare the glue.
3. Ruler or Meterstick.
4. Spirit level
5. Gluing brush
6. Brush and roller.
7. Cutter.
8. Soft sponge or cloth.
Prior to applicationPrepare the wall where you want to put the Wallpaper or Wall mural. The surface must be dry, clean and free of grease.
The material may cover small imperfections in the wall. However if there are deep cracks/grooves before wallpapering, they should be filled and smoothed. It is also necessary to remove any leftover residue from previous wallpapers/wall murals.
Prepare the glue, mix the 150g glue pack with 4-5 liters of water, stir continuously. This will produce an adequate amount of paste for 25 m2. Let the mixture stand for 5-10 minutes and then strir vigorously before applying.
* Due to the drying process of the glue, it is not recommended to apply wallpapers in rooms with low humidity and with temperatures of below 10ºC . The optimal room temperature during the application and drying process is between 18-21ºC
ApplicationWith a level and a ruler, mark vertical straight lines on the wall every 50cm. These lines will be where you apply the rolls of wallpaper or wall murals.
If there is a window in the wall you wish to apply the wallpaper on, we advise to start applying from the window frame and then go along the wall.
There are 2 different options for applying the glue -
1. With a brush, apply a thin layer of glue on the wall. This can be wider than the 50cm roll.
2. Starting from the center and working outwards, apply the glue onto the paper. Leave for a few minutes to dampeneping, ensuring to keep the glued bits in contact with each other (glue with glue), do this by folding the ends of the paper together.
Next, place the top end of the roll onto the wall. Brush from the center, to the sides.
Check to see if the wallpaper is aligned with the marking made on the wall previously. If not aligned, gently slide the roll across to the corret position.
Using the brush, press the wallpaper gently to remove any air bubbles. Make circular motions, starting from the top and working your way down. If you applied the glue to the wall then be careful to not get any glue on the brush.
Repeat these steps, making sure to align the edges.
If there is excess glue this can be removed wth a damp sponge or cloth.
After ApplicationEnsure that the wall paper or mural is flat against the entire wall.
Use the roller to smooth over the surface once more. Once the wallpaper has been applied, small bubbles may be visible. These will disapear over the next few days.
During the first few days after application it is important that the room temperaure remains constant, and remains above 10ºC. Avoid excessive heating of the room in which the wallpaper has been applied.
Expressleverans inom 24 timmar till din hemadress tillgänglig.